Thinklogical Configuring the TLX ASCII Interface Uživatelský manuál Strana 11

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 18
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 10
®
Configuring the TLX ASCII Interface 8 Rev. A - July, 2015
Log File Debugging Entries
When debugging is turned on, several types of messages are written to the system log file:
/var/log/api.
For example, below are listed five commands that were sent to a TLX320 Matrix Switch. Below
those commands is a snippet of the log file showing the corresponding log entries. The first line
in the log file records the event that enabled logging.
Ci0150o0151
Si0150
So0151
Do0151
Ci0312o0001
imxs tlxapi[1851]: caught signal SIGUSR1 (10), turn on api debugging
imxs tlxapi[1851]: command: Ci0150o0151 response: R0000OK#Ci0150o0151
imxs tlxapi[1851]: command: Si0150 response: R0000OKI0150O0151#Si0150
imxs tlxapi[1851]: command: So0151 response: R0000OKI0150O0151#So0151
imxs tlxapi[1851]: command: Do0151 response: R0000OK#Do0151
imxs tlxapi[1851]: command: Ci0312o0001 response: R0000OK#Ci0312o0001
These log entries list the command that was received and the response that was sent back to
the sender.
The log files contain other system related messages and are a valuable aid in troubleshooting.
Linux offers the means to send these log file entries over the network to another system. Further
information may be found in the document: Switch_Interfaces.
A Note to Telnet Users
By default, tlxapi does not send a CR on each line. This is inherent in the Windows telnet client
software. The API, however, has a command to enable the sending of CR's. This command is
XCRON. If your telnet output from tlxapi is displayed incorrectly on the screen, Thinklogical
recommends using the XCRON command.
Zobrazit stránku 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Komentáře k této Příručce

Žádné komentáře