Thinklogical Secure Console Server Manual Uživatelský manuál Strana 42

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 90
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 41
S e c u r e C o n s o l e S e r v e r M a n u a l , R e v . K
, J u l y , 2 0 1 3
Page 42
You will need the following information before running netconfig
:
Using DHCP/BOOTP (yes/no)? If No, you will need the following:
IP Address
Net Mask
Default Gateway
Primary Nameserver
You can add the secondary and tertiary nameservers (if required) by editing the resolv.conf
file at any time. After entering the requested information, you are returned to the root prompt.
See Section 7.2.2: More Than One Nameserver on page 43.
7.2.1.1 Save your netconfig changes
After running netconfig to set up your system, you must run the save command to
keep your changes. Then restart the network using the following steps:
1.
Make all changes
2.
Run save
3.
Run service network restart to restart the network
4.
Make a new ssh connection.
!
Note: If you are making several changes to the system configuration, you may
complete all the changes and then run save.
Example of
netconfig
fill-in fields
When you have filled in the fields, arrow down to the OK button and press Enter to accept
your entries.
Zobrazit stránku 41
1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 89 90

Komentáře k této Příručce

Žádné komentáře