Thinklogical Secure Console Server Manual Uživatelský manuál stáhnout pdf (Strana 43)

S e c u r e C o n s o l e S e r v e r M a n u a l , R e v . K

, J u l y , 2 0 1 3

Page 43

7.2.2 More Than One Nameserver

The netconfig

command allows the user to set up one nameserver’s IP address. It is

possible to have multiple nameservers, which must be done outside of the netconfig

command. The nameserver data is in the file /etc/resov.conf

If you want to have more

than one nameserver, you must edit the file

For more information, refer to the man page

for resolv.conf

In this file, you will find the IP address you entered with netconfig

You can add the

address of additional nameservers. (a maximum of 3 nameservers is allowed) to this file.

The format of a line is: nameserver <IP address>.

7.3 Change Hostname

The SCS includes a command changehostname

which allows the root user to change the

long hostname of the SCS unit.

1. Log in as root.

2. Type changehostname. The current hostname is displayed and you are prompted to

choose y/n to proceed.

3. If you select y (yes) to change, you are prompted to enter the new hostname.

Note: If you make a mistake in your entry, do not attempt to edit it. Reject the

incorrect entry and re-enter the value properly.

4. Enter your new hostname value. Press y to accept the new value.

5. Remember to run save when done to keep your new values.

6. After changing the hostname and/or clock settings, reboot to make the changes

permanent. These two settings (clock and hostname) are only saved during an

orderly shutdown. Loss of power before reboot will revert to the old values.

7.4 Time Configuration

Use the command timeconfig

to set up the date/time and time coordinates. This is a self-

prompting utility. To keep your values, run save

when completed. After changing clock

settings, reboot the SCS to make changes permanent.

Note: If changing the Time Zone (during timeconfig changes) restart the LCD

display service so the front panel display can update. Use the command service lcd

restart after completing the timeconfig options.

7.5 Change NIC Speed

You can change the NIC interface configuration to auto-sensing or fixed, to full or half duplex,

and to 10Mb or 100Mb. The following file information is found in the file /etc/modules.conf

with some additional instructions on to how to set the NIC speed.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 89 90

Komentáře k této Příručce

Žádné komentáře

Thinklogical Secure Console Server Manual Uživatelský manuál Strana 43

Komentáře k této Příručce